https://community.bt.com/t5/Archive-Staging/Smart-Hub-Technical-Log/m-p/2110421#M1208284 <P>The maximum data rate is a projected figure predicated on a particular SNRM figure. It is possible that when your line synced initially there was very little noise and thus a high sync speed. I suspect your noise margin figure is now very low and if you were to resync you would resync at a slower speed.</P> Sun, 08 Nov 2020 13:08:15 GMT licquorice 2020-11-08T13:08:15Z https://community.bt.com/t5/Archive-Staging/Smart-Hub-Technical-Log/m-p/2110403#M1208283 <P>I have a Smart Hub 2 with G.fast which generally performs well. However, when it comes to speed, I have noticed the following entries in the technical log</P><DIV><SPAN class="BTtitleFont">Data rate:</SPAN><SPAN class="BTregularFont">9.105 Mbps / 134.061 Mbps</SPAN><DIV class="mceNonEditable lia-copypaste-placeholder">&nbsp;</DIV><P>&nbsp;</P></DIV><DIV><SPAN class="BTtitleFont">Maximum data rate:</SPAN><SPAN class="BTregularFont">8.832 Mbps / 111.693 Mbps</SPAN></DIV><DIV>&nbsp;</DIV><DIV>How can the maximum data rate be less than the actual data rate? Is this a nonsense or am I just not understanding it properly?</DIV> Sun, 08 Nov 2020 12:17:22 GMT https://community.bt.com/t5/Archive-Staging/Smart-Hub-Technical-Log/m-p/2110403#M1208283 northshields 2020-11-08T12:17:22Z https://community.bt.com/t5/Archive-Staging/Smart-Hub-Technical-Log/m-p/2110421#M1208284 <P>The maximum data rate is a projected figure predicated on a particular SNRM figure. It is possible that when your line synced initially there was very little noise and thus a high sync speed. I suspect your noise margin figure is now very low and if you were to resync you would resync at a slower speed.</P> Sun, 08 Nov 2020 13:08:15 GMT https://community.bt.com/t5/Archive-Staging/Smart-Hub-Technical-Log/m-p/2110421#M1208284 licquorice 2020-11-08T13:08:15Z