This topic

No wired Ethernet- hub 5

circuitbender — Fri, 08 Apr 2022 14:50:15 GMT

Hi all

any ideas appreciated. I cannot connect my pc to any port on a hub 5, but I can connect a laptop to any port on the same hub 5 , no problem

weird thing is, the network adapter on pc works fine if I connect a wi-fi bridge to the pc ( wi-fi to Ethernet adapter)

ive disables/enable- uninstalled/reinstalled the network adapter, no joy? It’s not a dodgy Ethernet cable either, weird? - when pc connected to hub, it tries to connect, but doesn’t ( led’s associated with lan port flicker, then stop- flicker- then stop. Thanks in hope of any ideas

Re: No wired Ethernet- hub 5

Keith_Beddoe — Fri, 08 Apr 2022 14:57:55 GMT

@circuitbender

Do you have a spare Ethernet switch that you can put between the port on the home hub, and your PC, as its possible there is a hardware incompatibility issue which is causing auto-negotiation to fail? This issue has been reported before, usually where the PC has a 1Gb network card.

Also its possible that the PC network adapter is set to a fixed rate that the home hub cannot recognise.

Also see https://en.wikipedia.org/wiki/Duplex_mismatch

Re: No wired Ethernet- hub 5

Anonymous — Fri, 08 Apr 2022 16:14:40 GMT

Could you have set a static IP address on the PC previously for a router/the bridge with a different address range?

Run ipconfig from a command prompt & see if the ethernet card has an address in the 192.168.1.x range.

Re: No wired Ethernet- hub 5

circuitbender — Sat, 09 Apr 2022 07:19:44 GMT

Hi all, thanks for your replies

i haven’t got a spare Ethernet switch to put in between the hub and PC

the settings of the network interface adapter ( which is actually on the motherboard ) are as they should be , i checked the settings and there is no static ip address assigned, so it should automatically obtain an ip address. auto negotiate is set, so it should comfortably talk to the router.

The PC in question has 2 operating systems on it, - problem i have is no connectivity with win7. today , I'll boot it up to win xp just to see if theres a difference ( which i am doubtful of )

yesterday, I uninstalled the interface adapter ( nVidia ) - restarted PC and the OS detected the i/f adapter and installed the drivers successfully - but - still no joy with no connectivity with the hub ??

any more ideas please ?

Re: No wired Ethernet- hub 5

Keith_Beddoe — Sat, 09 Apr 2022 08:25:55 GMT

Try setting the network adapter to 100Mbs Full Duplex instead of auto negotiate. That would eliminate any issue with auto negotiation.

Re: No wired Ethernet- hub 5

Anonymous — Sat, 09 Apr 2022 09:20:53 GMT

Might also be worth setting a static IP address outside of the Hub's DHCP pool, which I think is below 64.

Re: No wired Ethernet- hub 5

circuitbender — Sat, 09 Apr 2022 09:37:51 GMT

thanks for that

what i did yesterday was disable DHCP, no joy

enable DHCP, still no joy

in both instances, hub Ethernet ports worked as normal with win10 laptop, but not the PC ?