This topic

Re: Using a Wi-Fi Extender on the Smart Hub 2

DonB9 — Sat, 26 Aug 2023 20:37:06 GMT

I am trying to get reasonable wifi to a CCTV camera at the side of my house. The BT Hub2 reaches 3 other cameras without any problem. I have now tried 3 Extenders from Amazon. The first was just useless and the second 2 TP-Link products seemed to match the router OK and I had all indicators showing a good connection. However, there was not even 1m extension to the router range. I have been in contact with TP support who were very attentive, but there best suggestion was a cable linked external access point. That is an expensive sledge hammer to crack a nut. The last extender tried (AX1800 RE605X) was installed and had the correct indications on the external wall concerned. Any suggestions or it will be going back to Amazon as well.

Re: Using a Wi-Fi Extender on the Smart Hub 2

Anonymous — Sat, 26 Aug 2023 21:20:42 GMT

Where are you placing the extenders? A common mistake is to place them next to the device you want to serve. In that scenario you are just trying to extend a weak/unusable signal. If you haven't already, initially pair next to the router & then try midway between the router & the problem device.

Re: Using a Wi-Fi Extender on the Smart Hub 2

Hildener — Sat, 26 Aug 2023 23:54:17 GMT

The Smart Hub 2 is designed to be used with the complete Wi-Fi Discs from BT the Black Discs. I have two of them and have a strong Signal all the way to my Summerhouse the Blink Outdoor Camera system works fine by accessing the nearest disc.

Re: Using a Wi-Fi Extender on the Smart Hub 2

spile — Sun, 27 Aug 2023 06:37:57 GMT

“there best suggestion was a cable linked external access point. “

That is excellent advice. Wired is always the best option especially for camera systems

Re: Using a Wi-Fi Extender on the Smart Hub 2

DonB9 — Sun, 27 Aug 2023 09:58:14 GMT

I set up the extender in the same room as the router and then move it as you suggest. However, the range of network does not seem to be extended. I have been through this process with TP support, but the range never seems to improve outside the house despite the extender being 10 m closer to the external wall than the router. I started with the cheaper end TPs at just over £20, but I am now trying with one at over £50 which is a much larger device with external aerials. The extenders just never seem to penetrate walls or windows like the router does.

Re: Using a Wi-Fi Extender on the Smart Hub 2

DonB9 — Sun, 27 Aug 2023 09:59:20 GMT

Thank you I will check the net for these devices.

Re: Using a Wi-Fi Extender on the Smart Hub 2

Anonymous — Sun, 27 Aug 2023 10:17:38 GMT

Just for a sanity check, you are connecting to the extender's SSID & not to the Hub's? An extender isn't a mesh so will have it's own SSID.

If you have good signal at the internal wall but not on the other side, maybe you have some kind of metallic insulation in between.

Re: Using a Wi-Fi Extender on the Smart Hub 2

DonB9 — Sun, 27 Aug 2023 11:24:40 GMT

I was expecting the extender to use hub's SSID. The camera system requires all cameras to be on the same SSID. The 3rd extender is winging its way back to Amazon as I type, I will have to look for an alternative. Cannot use mains line extender as it is on a different mains circuit.

Re: Using a Wi-Fi Extender on the Smart Hub 2

Anonymous — Sun, 27 Aug 2023 11:35:06 GMT

You may be able to change the extender's SSID to match the Hub but no idea if that would satisfy the camera software. You'd have to try it & see.

If not then you'll need a mesh system, but again you're in the world of an "expensive sledgehammer. Only cheap solution I can think of would be to buy a black BT mesh disc from Ebay or Facebook Marketplace, as I think that would replicate the Hub's SSID. But you'd need confirmation on that from someone using them & that a disc sourced through unofficial channels would work.

Edit: Looking the the specific extender you were using last, it appears that it can indeed replicate the Hub SSID.

https://www.tp-link.com/us/user-guides/re505x&re603x&re605x_v1/chapter-5-customize-your-network#ug-sub-title-2

Re: Using a Wi-Fi Extender on the Smart Hub 2

Keith_Beddoe — Sun, 27 Aug 2023 11:33:07 GMT

Mains linked wireless hotspots normally work fine, as long as both ends of the link go back to the same common mains consumer unit. They do not have to be on the same ring main.

Most houses only have one domestic single phase mains supply.

Wireless repeaters (extenders) are never a good solution.

Re: Using a Wi-Fi Extender on the Smart Hub 2

DonB9 — Sun, 27 Aug 2023 11:39:41 GMT

Will the mains linked extender use the same SSID? I have always understood that the mains extender had to be on the same ring cct and this was implied by TP support as the area where I will be working is in an extension to the hose. Both rings terminate on the same consumer unit. I have never tried these extenders before.

Re: Using a Wi-Fi Extender on the Smart Hub 2

DonB9 — Sun, 27 Aug 2023 11:41:00 GMT

I will check prices of the BT WiFi Discs, thank you.

Re: Using a Wi-Fi Extender on the Smart Hub 2

Keith_Beddoe — Sun, 27 Aug 2023 11:41:12 GMT

I use the TP Link Deco E4 three node system which works well for all my IP cameras, including a couple of bird box ones. This is configured in access point mode.

You can also set up a separate guest 2.4GHz only network which seems to suit many devices better. Just remember to allow local access.

A two node E4 costs about £49, one of which needs to be connected via Ethernet to the home hub. I am using a Home Hub 4 (ADSL), with its wireless turned off.

Re: Using a Wi-Fi Extender on the Smart Hub 2

DonB9 — Sun, 27 Aug 2023 11:48:30 GMT

Thank you, I was not aware that you could make adjustments to the home hub or the link extender. I am a beginner in wifi extenders and instructions enclosed with the devices are minimal. I don't want to run ethernet cables around the house. My wife would not be happy with the disruption to her decor.

Re: Using a Wi-Fi Extender on the Smart Hub 2

Oxonian — Sun, 27 Aug 2023 17:10:49 GMT

@DonB9

I have three of the black mini-discs from BT as part of my Halo 3+ ; no additional fee is payable.