Is this normal ?
The availability checker gives an estimate of 63-80 down, and 19-20 up.
When I had infinity2 installed, it connected at 44 / 7.
This has now dropped to 38 / 7
Is it normal for the estimate to be so far away from reality ? When I had an ADSL2 connection, the checker was pretty much bang-on.
Did you run this checker? It will show a Range A and a Range B. this will give a guide as to what range your line is in. The availability checker that BT use tends to only show the Range A speeds.
|FTTC Range A (Clean)||80||63.4||20||19.9||--||Available|
|FTTC Range B (Impacted)||75.1||47.3||20||16||--||Available|
So, I dont even get the low figure for upload speeds, and am 10mb below the low speed for downloads too.
|1. Product name:||BT Home Hub|
|2. Serial number:||+068343+NQ40506825|
|3. Firmware version:||Software version 18.104.22.168.22.214.171.124.6 (Type A) Last updated 26/02/14|
|4. Board version:||BT Hub 5A|
|5. VDSL uptime:||0 days, 01:27:25|
|6. Data rate:||7661 / 40242|
|7. Maximum data rate:||7114 / 47494|
|8. Noise margin:||5.8 / 6.3|
|9. Line attenuation:||0.0 / 24.2|
|10. Signal attenuation:||0.0 / 21.8|
What is it about the numbers ive posted that lead to you that?
If I'm going to argue my case, I need to understand a bit what I am arguing 😃
Or is it simply that the observed speeds are nowhere near those of the checker ?