I would hope the line now stays stable with the higher noise margin of 9db which if you can stay stable for 3+ days then you can get mmods to reset to 6db which will increase your conenction speed. you may even in time have your noise margin dropped to 3db which would give even more speed but can make some lines more prone to crc/hec errors which although faster connection speed acn slow down your downlodd speed
Our test also indicates that your line currently supports an estimated ADSL Max broadband line speed of 5.5Mbps; typically the line speed would range between 4Mbps and 8Mbps.
Our test also indicates that your line currently supports an estimated ADSL2+ broadband line speed of 7Mbps; typically the line speed would range between 4.5Mbps and 11.5Mbps. Our test also indicates that your line could support an estimated ADSL 2+ Annex-M broadband upstream line speed of 1Mbps and downstream line speed of 7Mbps; typically the downstream speed would range between 4.5Mbps and 11.5Mbps.
This has never been accurate though because I had 8mb on ADSL max and then went straight to 12.5mb on ADSL2+.
The attenuation checker on Kitz shows I should get roughly 16mb but I don't know how accurate that site is so someone will have to confirm.
Thanks for that information John and Jolly.
If there is nothing I can do to get more than 12.99 then that's fine but I'm sure you guys are just as keen on the internet as me and more speed is always better 🙂
If it means cutting out every 5 minutes though I won't but for now I'd like to see if it can go faster. I'd be gutted if it could and I didn't even try.
I still think with the current noise margin of 9db and the recent removal of bellwire that there is more speed available by getting noise margin down to 6db
Yes we only have two sockets and currently using the master socket near the front door and all others have been removed too.
Hope so Jolly! I'm nipping out in five minutes so I'll check back and see if anything happens when I get home thankyou for all the advice I won't be long!