HomeHub 3 - Broadband light flashing red, connects, drops flashes red - for last 2 days

[imjolly]

if your attenuation has increased as you say then that is a problem with your conenction and probably line resistence increasing your attenuation which as I said in normal circumstances should remain constant.

are you conencted to the test socket and have you tried a new filter.

is the quiet line test ok?

[KevinT]

just got home from a friends after ringing 150 to complain and i thought ehreee we go again... the router rebooted 3 times on the trot...but...but... its been stable for 10mins now AND  the phone does not say No Line.

here  is the new log  which in think is a n improvement,   also  my line speed has gone frm 5mb to 8

I wonder if calling 150 has spured them to check stuff.   they said i need engineer i said ok, if he is free.

ADSL Line Status

Connection Information Line state: Connected Connection time: 0 days, 00:09:26 Downstream: 7.938 Mbps Upstream: 448 Kbps

ADSL Settings VPI/VCI: 0/38 Type: PPPoA Modulation: G.992.1 Annex A Latency type: Interleaved Noise margin (Down/Up): 16.0 dB / 26.0 dB Line attenuation (Down/Up): 12.4 dB / 6.0 dB Output power (Down/Up): 19.9 dBm / 12.2 dBm FEC Events (Down/Up): 33 / 0 CRC Events (Down/Up): 1 / 0 Loss of Framing (Local/Remote): 0 / 0 Loss of Signal (Local/Remote): 0 / 0 Loss of Power (Local/Remote): 0 / 0 HEC Events (Down/Up): 0 / 0 Error Seconds (Local/Remote): 2560 / 1878

[imjolly]

certainly been fixed as attentuation now down to 12.4 and speed is max for adslmax conenction.  what about profile try btspeedtester and see if at 7.15mb

[KevinT]

do i need to rong 150 back   and cancel the engineer who is due on thrsday.... shall i leave it 24hrs ?

 Download speedachieved during the test was - 6.67 Mbps
 For your connection, the acceptable range of speeds is 0.6 Mbps-7.15 Mbps.
 Additional Information:
 Your DSL Connection Rate :8.13 Mbps(DOWN-STREAM), 0.45 Mbps(UP-STREAM)
 IP Profile for your line is - 7.15 Mbps

[imjolly]

I would wait the 24hrs as getting an engineer appointment can take a few days sometimes.  you can always cancel tomorrow as connection now looks good with correct profile - enjoy

[KevinT]

fingers crossed....

quiet test = quiet

wonder what would have happened to casue this so soon after engineer came round few weeks ago and rewired after master socket and lifted speed cap on line

[imjolly]

looks like something outwith your home which has now been fixed especially with the halving of your attenuation

[KevinT]

hmmmm router just rebooted twice in thr last 10 mins -  hope thats just the stabilisation

[imjolly]

hope so   connection speed still the same?

[john46]

post back hub stats and speed test in 24 hours please