Showing results for 
Show  only  | Search instead for 
Did you mean: 
Message 1 of 1

REIN detection

Chaps the standard detection for REIN I know is to look for intereference around 612khz but that is no good for me.


While I do have a rein engineer now looking at my line now I want to keep an eye on the line myself where possible not least since the engineer is based a long way away.


612 is no use for me I believe since I don't get any bitloading showing up at that frequency, mine due to line length tails off a long way before that and outwith the MW band.


What I really need to look at is around 500Khz since I often see no bits there but some either side however this sees to be between the LW and MW bands, Anyone any ideaa on how I would be able to detect these frequenies on ideally a portable device?

If my post was helpful then please click on the Ratings star on the left-hand side If the the reply answers your question fully then please select ’Mark as Accepted Solution’
0 Ratings