Wholehome App Updated Today. Still only shows 4 of 6 Disc

[Forthay]

I have a 6 disc setup and all discs show up in the web page. The Wholehome App was updated today with 6 disc support but I still only see 4 discs. Any ideas?

[Forthay · Accepted solution]

With the help of Joel from the BT Helpdesk (thank you) here is the solution that worked for me.

1. Turn off all the Discs except for Disk 1 which is connected to the router.

2. Factory reset Disc1 and allow it to connect

3. Start the BT App and go through the set up process for Disc 1

4. Now add the remaining 5 disc as normal.

in short it was a complete rebuild. My problem was Discs 5 and 6 we’re not Cloning after a factory reset.

[PaddyB]

Hi @Forthay,

I'm glad to hear the helpdesk was able to help. Thank you for taking the time to post back the solution.

Cheers

PaddyB

[Oxlade1]

You need to make sure your discs are on v1.02.01build24 before installing 5th and 6th discs, if anyone else has the same problem.

[Forthay]

No, you’re in correct for my case although you do need to make sure you have build 24. All my 6 discs were already v1.02.01build24 and the app was fully up to date. The problem was two fold
1. If you have an existing working 6 disc setup and install the latest app it did not recognise discs 5/6 although they could be seen in the web browser admin tool. In an attempt to resolve this I attempted a factory reset of disc 5 which went red after removing the Ethernet cable.
2. To resolve the problem of the red light which was caused by the primary disc 1 details not being cloned to disc 5 a reset of disc 1 and a rebuild of the network was required by adding all 5 discs one after another.