Hi everybody,
It’s that time again. We're releasing new firmware today for your Whole Home Wi-Fi discs.
What’s new? This new version v1.02.06 build12, includes the following two improvements:
Upgrade advice:
Community Moderator | NeilO | |
Did you get the help you needed? Help others by clicking on ‘Mark as accepted solution’ | Show your appreciation! Click on the star next to a reply to say thanks | Help guide to using the community? Click below |
Please avoid contacting us (moderators) via private message, for account/fault issues, unless invited to do so. The community will be able to help answer your question so we encourage you to create a new thread if you can’t find the answer from existing discussions. The moderators will be around to lend a hand should the community not have the answers. Thank You |
Good news and thanks for the update - hopefully this will address the issues with Apple devices dropping out. One minor point - can no lonfer access http://mybtdevice.home - has this changed?
Thanks in advance
No changes to mybtdevice.home. Reboot your discs if that's not working. Once rebooted, leave them to settle for a couple of days. Everything should still work during that time, but you may see short drops.
BT Device Expert | Bruno | |
Did you get the help you needed? Help others by clicking on ‘Mark as accepted solution’ | Show your appreciation! Click on the thumbs up next to a reply to say thanks | Help guide to using the community? Click below |
I am a BT Employee and an expert on BT Devices queries. I am here volunteering my own time to give advice, and help where I can with BT device queries. Go here for more info. |
That worked - thanks. I still have steering disabled. Shall I give it a couple of days to bed in then try re-enabling?
Yes, Apple dropouts, especially iPad, has been a perpetual bugbear. Last firmware seemed to improve things but still got a very occasional iPad wobbly when it would just keep connecting and disconnecting every few seconds...all other devices would be fine.
Ok, have re-enabled 'steering' today - will see how the system behaves over next couple of days.
After firmware updat my holwe system is dead. Each disk as the slow blue light flashing. Nothing connects.
Not good!
@Yelekrebwrote:Ok, have re-enabled 'steering' today - will see how the system behaves over next couple of days.
How has it gone with steering enabled? The only device on the old disc firmware that i still had an issue with if legacy steering is enabled was my Netatamo thermostat. It would lose connection after 2 or 3 days tops and required rebooting to connect again, with legacy steering disabled it stays connected just fine.