If I use the web interface (mybtdevice.home) to manage the Home Hub WifFi some of the screens are blank unless I do multiple refreshes. For example, Status/Overview, Status/Devices, Settings/Access Control, Settings/IP Addressing, Settings/Internet, System/Information and System/System Log.
It was fine before the last firmware update.
This happens to me too; started suddenly and can't make it go away depspite restarts.
Same for my system, was OK for the first couple of days after upgrading to latest latest firmware.
I am also now finding that a few days on, not only are the Overview and Devices pages blank, but the iOS app stops talking altogther to the Whole Home Setup - it reports not connected.
The Web screens apprear to work, but are really dead, ie checking for firmware, logs and restart all fail.
Only way to resolve is to power cycle the Master disc.
@Dan-O hopefully your aware of these issues with the latest firmware?
On the postive, my devices are now using nearby discs all the time. Previously some would "wonder off" to a <very> distant disc and then struggle 🙂
|Did you get the help you needed?|
Help others by clicking on ‘Mark as accepted solution’
|Show your appreciation!|
Click on the star next to a reply to say thanks
|Help guide to using the community? Click below|
|I am a BT Employee and an expert on BT Devices queries. I am here volunteering my own time to give advice, and help where I can with BT device queries. Go here for more info.|