Could anyone offer any advice as to how to configure this router with BTTV and the YV box?
I've tried to copy some settings from my previous router (Asus N66U).
IGMP snooping - Enabled
IGMP Proxy - Enabled
IGMP version 2
In the IPTV section there is a dropdown box which has 3 options:
Manual - it requests a VID and Priority. Also have to select Tagged or Untagged.
Profile - Several pre-configured profiles e.g. Starhub, Vodafone, Spark, Meo, Slingshot, Movistar XS4all
IPTV STB port (with Asus N66U this was always disabled) - I can select either LAN3 or LAN4 as either Internet or IPTV
I had it working late-on last night but wasn't able to test it for too long. When I got back from work this evening, I was told the TV had been freezing and breaking-up for most of the day. I've now had to revert back to the BT Homehub to stop the family shouting (Asus router is not used).
The YouView board is for problems with the YouView box or content issues. Stephanie has not been on this forum for a long time now, and the general broadband board did not exist then.
Subsequent discussions relating to which routers support multicast, are now on the general broadband board.
This keeps the Youview board free for new posters who are having difficulty with their YouView box, and do not want to read large discussions about routers. There is also specialist support on the YouView board, by BT technical experts.
Bit late in the day but for anyone in the same situation this is what worked for me:
BT Openreach modem (Huawei EchoLife HG612 3B)
BT YouView+ box (Humax DTR-T2100)
Password: bt [but I think anything works]
Initially both Internet and TV appeared to work but no response from BT Player button and no subscription channels (eg BT Sport).
Additional Synology settings
Under Local Network/General:
Both modem and router used IP address 192.168.1.1 so changed router's to 192.168.1.2
Start IP address: 192.168.1.3
Primary DNS: 192.168.1.2
(Don't know if that was necessary but didn't do any harm.)
Changed IGMP Proxy to 'Enabled''
Under Local Network/IPTV & VoIP:
Select 'Enable IPTV & VoIP''
Mode: IPTV STB port
All other settings unchanged.
Going back to my first post at the top, can anyone advise what values I need to use for VID, Priority and tagged or untagged?
I want to manually set up a port on my RT2600AC specifically for BT IPTV and it requires these 3 parameters.
BTW, has anyone who has updated to SRM 1.2-7742 Update 1 confirm that in order to get BT IPTV working, you have to select IGMP version 2 (not version 3)? This had me stumped after the recent firmware update and only discovered this today after trial-and-error.