Draytek 130 / Netgear Mesh MK62 Setup to replace HHub6

[markgpowell]

I am looking to replace my HHub6 with a Draktek Vigor 130 and Netgear Mesh MK62.

I can connect my Netgear to the HHub 6 and it works well but I want to use a Draytek Vigor 130 instead.

Can anybody help with what I need.

I tried to set the Netgear to IPv6 connection type of PPPoE and put in an Id of bthomehub@btbroadband.com with a password of BT....  and didn't change anything else but cannot get this to work

Any ideas?

[Stu_H]

Your user name is your primary email ie. mark@btinternet.com and password just put BT.

[markgpowell]

Thank you Stu

so just email and password of BT.

No other settings on either the router or the modem?

[Stu_H]

Modem should be plug and play and then you just need to go through the settings in router which apply to you.

[Stu_H]

Don’t forget, boot modem up first, allow a good 2 mins, then boot router and setup 

[licquorice]

---

@Stu_H wrote:

Your user name is your primary email ie. mark@btinternet.com and password just put BT.

---

No it isn't, completely wrong.

It is bthomehub@btbroadband.com

[Stu_H]

That’s strange, mines my email.

ive used that in my routers with various modems. I’m using a RAX120 at the mo. 

[licquorice]

I very much doubt it, the part after the @ is btbroadband.com not btinternet.com.

[Stu_H]

No, just looking at mine is btinternet.com And I’m using it now 

perhaps it depends on age of account?

[licquorice]

That really is weird as that was a common mistake people made using btinternet rather than btbroadband which prevented them connecting. Perhaps they have changed it recently to allow btinternet. The part before the @ never mattered.