cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
mojonaut
Aspiring Contributor
837 Views
Message 1 of 2

Hub6 No wifi access, ethernet is ok and working

Go to solution

I suddenly can't connect via wifi from my PC Laptop or iPod, I've installed a wifi sniffer on the laptop and local hubs in the vicinity can be seen but mine doesn't show. Connecting the laptop via ethernet works fine.

On the hub status page, wifi is shown as OFF but in the wifi settings page it is shown as ON.

I have tried turning the wifi on and off and have reset the hub and also done a power cycle.

Do I have a hardware fault or is there a setting I'm overlooking?

 

Fullscreen capture 28072019 101323.jpgFullscreen capture 28072019 101338.jpg

 

 

0 Ratings
Reply
1 REPLY 1
imjolly
Distinguished Sage
Distinguished Sage
836 Views
Message 2 of 2

Re: Hub6 No wifi access, ethernet is ok and working

Go to solution

if factory reset by pressing recessed button on back and holding till lights flash does not get wireless working again then you need to phone CS and asked for replacement which is free as long as still in fixed term contract



If you like a post, or want to say thanks for a helpful answer, please click on the Ratings 'Thumbs up' on left hand side.
If someone answers your question correctly please let other members know by clicking on ’Mark as Accepted Solution’.