on 11-12-2012 17h45
I've just changed from TalkTalk to BT. The internet works fine, but on the old set up, I could print wirelessly by connecting my printer (HP 6300 series) to the router by ethernet cable. It won't work with the new Home Hub. Any suggestions??
Hope someone can help.
Solved! Go to Solution.
on 11-12-2012 21h27
on 12-12-2012 10h57
Thanks for that, but it doesn't work that way, unless I'm missing something. The printer isn't a "wireless" printer as such. It's connected to the router (Home Hub) by an ethernet cable, a method which worked OK with the previous Netgear router, but not this one (the internet works fine, BTW). If I do "Add a Printer", the new router doesn't detect the printer.
on 12-12-2012 11h42
Remember, the IP subnet is different from the Netgear, so you will need to make some changes to the printers IP address.
Forumhelp (Private website) Lots of additional information and help.
You will need to be connected to your home BT Broadband connection to view it, or any links to it that I post on this forum.
on 15-12-2012 13h13
Thanks for that. I followed your advice (obvious once it's pointed out) and changed the network settings on the printer. Unfortunately it still didn't work - GRRR!
In the process, I did discover how to open the Homehub admin - bthomehub.home doesn't work - you just get a Google search showing the results of other people's unsuccessful attempts. However, if anyone's interested, going into the network settings on your computer gets you the right IP address (192.168.1.65 in my case). So my 2 hrs work wasn't entirely wasted.
Thanks anyway - any oter ideas??
on 15-12-2012 13h42
Oops. My last post was based on the fact that 'Add a printer' didn't work. However, I noticed that the printer was listed as being connected to my computer, and I found it on the list of installed printers, completed the installation and it worked. So, please ignore my previous message, except the bit about how to access the Homehub.
Many thanks. I shall mark this as an accepted solution,
on 25-12-2012 22h38
I'm having the same problem. I can't add my printer. I've changed the IP address and still the computer won't communicate with the printer. Updated all my software. It worked fine when connected to my Airport extreme which was connected to a netgear router. This upgrade ws supposed to be progress. Any suggestions