Ethernet cable installation issues

[penguin23]

hi

I have success fully run the broadband signal from master socket to Bt home hub 6 using one of the twisted pairs of an ethernet cable

I now want to run ethernet back from hub to where master socket is using only 2 of the pairs in the ethernet cable

I did this using one pair on 1 and 2 and another pair on pins 3 and 6 and using a cable tester i can confirm that pins 1,2,3 and 6 are directly connected.

So my question is does the home hub 6 support 2 pair (4 wire ethernet) or have i done something wrong

I know that the port on the hub works as i have tested with a normal ethernet cable plugged into the port

i would rather not have this ethernet connection then move my hub to the master socket

Thanks

[licquorice]

---

@penguin23 wrote:

I did this using one pair on 1 and 2 and another pair on pins 3 and 6 and using a cable tester i can confirm that pins 1,2,3 and 4 are directly connected.

I assume that is a typo and you mean 6

So my question is does the home hub 6 support 2 pair (4 wire ethernet) or have i done something wrong

The Ethernet ports are GbE but should work at 100M with 4 wires but can't confirm 100% that they will. Did you restrict whatever device you connected to 100M?

---

[penguin23]

sorry yeah that was a typo

not sure how to restrict my laptop to 100M

[licquorice]

Select your NIC in Network Connections then click on configure then advanced tab. Select 100M full duplex.

[penguin23]

unfortunately selecting 100M full duplex didn't work

[licquorice]

I have a SH2 hub and I've just butchered an Ethernet lead and it works fine with just 1,2,3 and 6 connected. That's without changing the NIC from auto negotiation.

[penguin23]

so i used a cheap cable cutting wires 4,5,7,8 and it still worked with the bthub

I tired putting the broadband signal on a separate cable thinking that it might be causing interference but no luck so my guess is that i have just exceeded the max length for 2 pair ethernet even through my run is only 5m

Thanks for your help though

[licquorice]

Are you sure the plugs are properly crimped?  It should work fine for 100M

[penguin23 · Accepted solution]

I got it working the first time I had crimped it badly but I thought it was I problem at the keystone so I repeatly punched down those cables which damaged them I then recrimped the other end properly but now the damage cables didn't work which is when I posted my problem so I just cut them back and soldered/ extended them and now it works.          

Thanks for your help

[licquorice]

Glad you got it sorted