- « Previous
-
- 1
- 2
- Next »
bratman91
Aspiring Expert
- Mark as New
- Bookmark
- Subscribe
- Subscribe to this message's RSS Feed
- Highlight this Message
- Report Inappropriate Content
Re: Extension cable from wall plate to router
Many thanks for that clarification. There is nothing on the plug that extends beyond the faceplate surface so it looks like the release clip has indeed been broken off, misleading me to think that it cannot be unplugged.
0
Ratings
licquorice
Distinguished Sage
- Mark as New
- Bookmark
- Subscribe
- Subscribe to this message's RSS Feed
- Highlight this Message
- Report Inappropriate Content
Re: Extension cable from wall plate to router
You might be able to release it by manipulating it with a thin bladed knife.
0
Ratings
imjolly
Distinguished Sage
- Mark as New
- Bookmark
- Subscribe
- Subscribe to this message's RSS Feed
- Highlight this Message
- Report Inappropriate Content
If you can't free cable with knife or screwdriver then take of bottom plate the remove middle section shown by yellow arrow and then you should be able to remove cable. Then just put middles cation back and replace front bottom section. You can then buy a new rj11 to rj11 cable for the length you need
If you like a post, or want to say thanks for a helpful answer, please click on the Ratings 'Thumbs up' on left hand side.
If someone answers your question correctly please let other members know by clicking on ’Mark as Accepted Solution’.
bratman91
Aspiring Expert
- Mark as New
- Bookmark
- Subscribe
- Subscribe to this message's RSS Feed
- Highlight this Message
- Report Inappropriate Content
Re: Extension cable from wall plate to router
Thank you, licquorice, I had marked imjolly’s reply as an acceptable solution and I wasn’t able to repeat this on you solution.
0
Ratings
- « Previous
-
- 1
- 2
- Next »