cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
3,215 Views
Message 1 of 6

Third party router problems

Go to solution

Hi all,

I have a wierd problem with my zyxel VMG8924 on my ADSL connection. I use the zyxel as it has a very good chipset for my longer line and the built in noise filter etc.

When I connect my ADSL it works flawless for maybe a few hours, then the by connections stops responding? 

My sync stays up and the ppoa connection says connected but the BT network stops responding (won't load web pages , speed test error etc)

When I drop the ppoa connection and connect again the problem still persists.

I'm really scratching my head on this one as neither the ppoa or sync drops, just by stops responding after a few hours.

Have triple checked all settings and all correct, have never had this problem before, would anyone have any idea what's causing this?

Thanks

 

0 Ratings
5 REPLIES 5
3,212 Views
Message 2 of 6

Re: Third party router problems

Go to solution

My settings are as follows- 

Bthomehub@btbroadband.com ( also tried btbroadbanduser@btbroadband.com)

Password - BT 

Ppoa, 0/38,

VC Mux without PCR,

CHAP

dle timeout 0

 

 

 

 

0 Ratings
3,195 Views
Message 3 of 6

Re: Third party router problems

Go to solution

Might be worth asking over on Kitz https://forum.kitz.co.uk/ there are a number of Zyxel experts there.

3,186 Views
Message 4 of 6

Re: Third party router problems

Go to solution

Thanks for that, I will definitely do that 😉

Would you recom it's a router problem more than a BT problem?

0 Ratings
3,178 Views
Message 5 of 6

Re: Third party router problems

Go to solution

Difficult to say, its odd that it works for a while and stops working. If you still have a BT hub, it might be worth trying it for a while to see if the same thing happens with that.

0 Ratings
3,157 Views
Message 6 of 6

Re: Third party router problems

Go to solution

Took your advice, went into kitz, found out the particular firmware I was using had a known bug with the ppoa.

Updated the firmware to a newer version and voila, all been good since, with the bonus of much reduced error rates as well.

Thanks for the help 😉

0 Ratings