Hi there,
We recently moved to Fibre and ethernet conenctions around the house.
Since using this i notice the following messages in my SmartHub's log
12:00:33, 14 Apr.
A device connected to Ethernet port 2
12:00:33, 14 Apr.
Wire Lan Port 2 up, Speed 100 Mbps
12:00:07, 14 Apr.
A device disconnected from Ethernet port 2
12:00:07, 14 Apr.
Wire Lan Port 2 down, Speed 10 Mbps
12:00:06, 14 Apr.
A device connected to Ethernet port 2
12:00:06, 14 Apr.
Wire Lan Port 2 up, Speed 100 Mbps
11:59:34, 14 Apr.
A device disconnected from Ethernet port 2
11:59:34, 14 Apr.
Wire Lan Port 2 down, Speed 10 Mbps
11:59:32, 14 Apr.
A device connected to Ethernet port 2
11:59:32, 14 Apr.
Wire Lan Port 2 up, Speed 100 Mbps
11:59:29, 14 Apr.
A device disconnected from Ethernet port 2
11:59:29, 14 Apr.
Wire Lan Port 2 down, Speed 10 Mbps
11:59:27, 14 Apr.
A device connected to Ethernet port 2
11:59:27, 14 Apr.
Wire Lan Port 2 up, Speed 100 Mbps
11:59:09, 14 Apr.
A device disconnected from Ethernet port 2
11:59:09, 14 Apr.
Wire Lan Port 2 down, Speed 10 Mbps
The port in question runs via Cat 6 to one single PC, directly connected into the ethernet ( i.e. not via an intervening switch)
I did try swapping cables for port 2 and 1 on the homehub to see if this was tied to the physical port on the hub but the messages moved t the new port number which suggests its related to the device connected to the other end, i.e. this one PC. When I have been using that PC for testing it gets full speed speed tests so is connected at a good speed. It doesn't seem limited to 10/100
What do these frequent Port Up / Down messages mean? Is it actually a problem?
