cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
776 Views
Message 11 of 17

Re: Tp Link Deco E4 setup

@Ohgivemeabreak  Lets start again.

What physical connections have you made, what ports are connected where?

0 Ratings
Reply
775 Views
Message 12 of 17

Re: Tp Link Deco E4 setup

@licquorice 

That only applies if you are connecting it to a modem.

I an sure there was a setup wizard to auto detect the connection type.

 

0 Ratings
Reply
770 Views
Message 13 of 17

Re: Tp Link Deco E4 setup

@Keith_Beddoe  The OP hasn't specified how he is connecting the device. We don't know if he is connecting to a BT Hub or directly to the ONT.

0 Ratings
Reply
766 Views
Message 14 of 17

Re: Tp Link Deco E4 setup

Just see https://www.tp-link.com/uk/support/faq/2464/

Connect the first unit to an Ethernet port on the home hub, the Deco will see that as a modem and allow Internet access.

You then change it to access mode, it then reboots, and that is it.

You can then add extra nodes via the app.

It cannot get any simpler.

 

0 Ratings
Reply
755 Views
Message 15 of 17

Re: Tp Link Deco E4 setup

First post "I'm fibre to cabinet, then good old copper wire to property."

0 Ratings
Reply
754 Views
Message 16 of 17

Re: Tp Link Deco E4 setup

Missed that

0 Ratings
Reply
747 Views
Message 17 of 17

Re: Tp Link Deco E4 setup

@Ohgivemeabreak 

If you simply follow the instructions, it automatically gets an IP (LAN) address from the home hub to start with. That allows an Internet connection to register the device against your TP Link ID.

You then simply change the mode from the advanced menu.

If you think you have done it wrong, then simply factory reset it, and start again and let it detect the connection type.

 

0 Ratings
Reply