cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Anonymous
Not applicable
3,400 Views
Message 1 of 6

Curious about noise margin and line attenuation

Go to solution

I have had a few issues with my line disconnecting over the last few months, the first culprit being a waterlogged underground access hatch.

But after a solid week the drops have returned (17 disconnections yesterday was a new record), so Openreach are due again on Monday, plus I have had a new Smart Hub 2 just in case. Touch wood the connection has settled for the last 17 hours bar a disconnection around 4 hours ago. 

I pay for Fibre 2 because I would like to access the higher upload speed which my line is supposedly capable of handling, but alas no one at BT will actually put me on that profile. 

As I have had issues I have been looking at the stats I became curious about noise margin because after looking through the forum I'm not sure what is good or bad?

When you look at noise and line attenuation, is the first number in the hub the actual and the second the target or vice versa? Is a higher or lower number preferred?

Just curious and trying to learn because we are not on any FTTP upgrade plans so stuck with copper for many years yet potentially.

Hub StatsHub Stats

0 Ratings
Reply
5 REPLIES 5
3,377 Views
Message 2 of 6

Re: Curious about noise margin and line attenuation

Go to solution

I would turn FTTP mode to off and get use of ethernet port 4

The line attenuation give indication of distance from the street cabinet and lower the closer to cabinet the faster your speed.  the normal noise margin is 6db.  yours is just below that as your actual speed is slightly faster than your attainable speed.



If you like a post, or want to say thanks for a helpful answer, please click on the Ratings 'Thumbs up' on left hand side.
If someone answers your question correctly please let other members know by clicking on ’Mark as Accepted Solution’.
Anonymous
Not applicable
3,354 Views
Message 3 of 6

Re: Curious about noise margin and line attenuation

Go to solution

Brilliant, thank you.

I forgot about the FTTP port setting as well so great reminder! 

0 Ratings
Reply
3,350 Views
Message 4 of 6

Re: Curious about noise margin and line attenuation

Go to solution

The figures are actual for upstream/downstream

Anonymous
Not applicable
3,328 Views
Message 5 of 6

Re: Curious about noise margin and line attenuation

Go to solution

@licquoricewrote:

The figures are actual for upstream/downstream

Thanks

So a Noise Margin of 11.5 / 5.1 is:

  • 11.5 on the upstream
  • 5.1 on the downstream

Is that correct?

0 Ratings
Reply
3,323 Views
Message 6 of 6

Re: Curious about noise margin and line attenuation

Go to solution

Correct. As your upstream is capped at 10M but your attainable is 17M you have a high noise margin.