cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
3,355 Views
Message 11 of 37

Re: Using Full Fibre 100 with third-party router and Digital Voice

Go to solution

I think there's likely to be a world of pain trying to route a DrayTek router via a SH2 without a bridge mode.  They charge for DV so if they won't provide a real landline I think we'll just go without a landline and use mobile.  Maybe if enough people refuse DV they will change their restrictive practices and open up the service to other routers.  Or provide an adapter that can be plugged into other routers.

0 Ratings
Reply
3,347 Views
Message 12 of 37

Re: Using Full Fibre 100 with third-party router and Digital Voice

Go to solution

No they won't. It is a deliberate decision in order to provide a more secure VoIP solution.

Like many others, you have failed to understand that BT is a mass market ISP and for 99% of its customer base it provides all their requirements. They are not going to change their business model and spend money to suit a very tiny minority of their customers.

3,344 Views
Message 13 of 37

Re: Using Full Fibre 100 with third-party router and Digital Voice

Go to solution

This is affecting all providers.

The reason for this, is explained on this two page website.

https://www.draytek.co.uk/information/blog/the-end-of-analogue-phone-lines-pt1

0 Ratings
Reply
3,340 Views
Message 14 of 37

Re: Using Full Fibre 100 with third-party router and Digital Voice

Go to solution

Oh well, it sounds like it will have to be a mobile-phone based "landline" then.  Saves me a bit of money paying BT for DV I suppose.

0 Ratings
Reply
3,337 Views
Message 15 of 37

Re: Using Full Fibre 100 with third-party router and Digital Voice

Go to solution

It won't save you a lot I'm afraid, possibly a maximum of £5/m if that.

0 Ratings
Reply
3,311 Views
Message 16 of 37

Re: Using Full Fibre 100 with third-party router and Digital Voice

Go to solution

How “Smart” is the Smart Hub 2?  Does it let you set up port-forwarding/redirection to different devices on the LAN?  And have Dynamic DNS support built in?  Is there a manual online describing all its functionality.  The HomeHub was pretty hopeless but before rejecting the SH2 I should at least check out whether it’s equally feature-free or has improved since the HH.

0 Ratings
Reply
3,306 Views
Message 17 of 37

Re: Using Full Fibre 100 with third-party router and Digital Voice

Go to solution

Yes, it has port forwarding capability and  limited DDNS support (DynDNS, NoIP, ChangeIP, EasyDNS, Zoneedit DNS-O-Matic). The DHCP range can be amended and has address reservation capability (although that can sometimes be a bit flaky, better to use static addresses)

The big downside for many is the inability to give the WiFi bands different SSIDs.

0 Ratings
Reply
3,277 Views
Message 18 of 37

Re: Using Full Fibre 100 with third-party router and Digital Voice

Go to solution

Thank you for the information.  That's a bit more encouraging than I thought it might be.

0 Ratings
Reply
3,186 Views
Message 19 of 37

Re: Using Full Fibre 100 with third-party router and Digital Voice

Go to solution
That an an inability to change DNS servers.
And an inability to enable DNS Rebinding if there is a need to (re)direct a DNS lookup to a local IP through the router. But I think that will have a limited use case!

0 Ratings
Reply
3,146 Views
Message 20 of 37

Re: Using Full Fibre 100 with third-party router and Digital Voice

Go to solution

Let's be honest, it's a deliberate decision to provide vendor lock in, not a more secure VoIP solution.  As any security expert will tell you, open standards get far more scrutiny and are inherently more secure than proprietary, closed standards.  BT could have chosen to adopt an open standard here, which would have allowed customers more flexibility when choosing their equipment, including handsets, which will just end up in landfill now when people move to a new provider.

0 Ratings
Reply