cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
2,076 Views
Message 1 of 9

Hub settings for an apache server using SSL

Go to solution

Is there a setting on the hub required if using apache and ssl?

Does anyone have an example of a site config file for such a server?

Dave

0 Ratings
Reply
8 REPLIES 8
2,056 Views
Message 2 of 9

Re: Hub settings for an apache server using SSL

Go to solution

@dfl1955 wrote:

Is there a setting on the hub required if using apache and ssl?

 


No

0 Ratings
Reply
2,048 Views
Message 3 of 9

Re: Hub settings for an apache server using SSL

Go to solution

Do you have an example of a config file?

 

D

0 Ratings
Reply
2,044 Views
Message 4 of 9

Re: Hub settings for an apache server using SSL

Go to solution

No, sorry. You would be better asking on either an Apache forum or your operating system's forum. It's not a BT thing.

0 Ratings
Reply
2,024 Views
Message 5 of 9

Re: Hub settings for an apache server using SSL

Go to solution

The BT Smart Hub's firewall is just controlling what can go in and out based on a Layer 3 network.  So source IP addresses, destination IP addresses, port and protocol. It's not doing any TLS termination, mutual SSL auth, ect...

As @licquorice  has said you'll need to onto the Apache developer forum or the developer forum of the software or hardware you're trying configure and use.

Tip though, some opensource certificate authorities such as let's encrypt have packages you can use that help automate the configuration and rotate the certificate for you that work with Nginx or Apache.

2,017 Views
Message 6 of 9

Re: Hub settings for an apache server using SSL

Go to solution

If you just want the hub settings to forward traffic to an Apache server on your home network, it should be as simple as forwarding TCP ports 80 and 443 to your server's internal IP address.

The rules are configured in 'Advanced Settings -> Firewall -> Port Forwarding'

You should then be able to connect from outside your home network to that server using your public IP address.  Bear in mind that this can change following a hub restart.

1,969 Views
Message 7 of 9

Re: Hub settings for an apache server using SSL

Go to solution

On my hub, the firewall rules for http and https are separate. I needed to install a second rule for https on the firewalls panel.

BT Home Hub 5 (Type A) | Software version 4.7.5.1.83.8.264

 

Thanks for your help. <nosarcasm>

 

 

0 Ratings
Reply
1,964 Views
Message 8 of 9

Re: Hub settings for an apache server using SSL

Go to solution

It seems I had discovered the correct apache configs, the problem was I needed an https firewall rule.

0 Ratings
Reply
1,961 Views
Message 9 of 9

Re: Hub settings for an apache server using SSL

Go to solution

Thank you I consider this the best answer. Could whoever marked this as complete change the pointer to @ptrduffy 's reply.

0 Ratings
Reply