Hybrid Connect Hub setup issue. Solid white BT logo light that flashes red sometimes.
Its been doing this for a while now after sort of working out that white BT logo light meant "firmware update required" so i followed these instructions and now its doing what the Title suggests:
"Firmware update required.
Disconnect the Hybrid Connect from the Hub, then perform a Factory Reset on the Hybrid Connect by pressing the pinhole reset button on the back for 15 seconds. Once the circle starts flashing green, connect the Hybrid Connect to the Hub via Ethernet and then leave for 30 minutes to set up."
Anyone else done this and had success ? is it just doing loads of updates over and over or something ?
