cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
674 Views
Message 11 of 17

Re: Solid orange light - no master socket, but switch

In that case, there must be a master socket somewhere.  The same connection setup applies but the router connects to the master socket via the DSL port.  The WAN port is not used.

0 Ratings
Reply
671 Views
Message 12 of 17

Re: Solid orange light - no master socket, but switch

from your post there is no FTTP available to you only FTTC.  you need to try and trace where the incoming black cable ends up and if connected to anything



If you like a post, or want to say thanks for a helpful answer, please click on the Ratings 'Thumbs up' on left hand side.
If someone answers your question correctly please let other members know by clicking on ’Mark as Accepted Solution’.
0 Ratings
Reply
668 Views
Message 13 of 17

Re: Solid orange light - no master socket, but switch

Thanks will look again but is a mystery. 

0 Ratings
Reply
636 Views
Message 14 of 17

Re: Solid orange light - no master socket, but switch

When was the activation date? If that has passed it may be worth connecting a computer to the switch to see if there's anything live. Or scan for existing WiFi network just in case a Hub has been boxed in somewhere. Does the switch & wiring look new? If not it could be left over from whatever was there pre-refurb.

Among you documents from your solicitor should be a schedule of fixtures & fittings. Maybe see if anything relevant is listed there. It's possible the master socket was removed during the refurb & not replaced.

 

0 Ratings
Reply
628 Views
Message 15 of 17

Re: Solid orange light - no master socket, but switch

@rbz5416 

already has SH2 connected to switch according to initial post



If you like a post, or want to say thanks for a helpful answer, please click on the Ratings 'Thumbs up' on left hand side.
If someone answers your question correctly please let other members know by clicking on ’Mark as Accepted Solution’.
0 Ratings
Reply
625 Views
Message 16 of 17

Re: Solid orange light - no master socket, but switch


@imjollywrote:

@rbz5416 

already has SH2 connected to switch according to initial post


Yes, but if there's another Hub in place somewhere feeding the switch, that would explain the orange LED as it will be operating as an AP. All just speculation really given what we know...

0 Ratings
Reply
573 Views
Message 17 of 17

Re: Solid orange light - no master socket, but switch

If the place has been refurbished and the OP has looked but can’t find an Openreach master socket it’s a reasonable assumption that it’s been removed part of the refurbishment ….if the property is similar to the surrounding ones , and serviced underground, check to see if where the underground cable surfaces, or if overhead , does a wire from the pole exist .

If the property had service previously , which was removed during the refurbishment then obviously neither the ISP or Openreach will be aware of this and the ( self install ) order will proceed without any chance of success, the OP either needs to report a fault , wait and hope the service is picked up by Openreach as not working ( an ELF early life failure ) or look to reinstate whatever the developer removed 

FWIW , there was never any evidence or suggestion that FTTP was available, yet the thread went off on a bit of a FTTP tangent.

0 Ratings
Reply