CliffordM
Aspiring Contributor
- Mark as New
- Bookmark
- Subscribe
- Subscribe to this message's RSS Feed
- Highlight this Message
- Report Inappropriate Content
Hi, Waited 3 weeks for Install, OR engineer been out and installed CSP/ONT but said Its set to SASA2 not SASA1?
I believe its an exchange issue, Is anyway of getting it escalated as I'm on temp Mini hub that's 2-3mb in my area and team calls & meetings ect are painful let alone the kids battering me for youtube!
Any help would be great as I'm a homeworker.
Many thanks
Mike.
Solved! Go to Solution.
0
Ratings
4 REPLIES 4
licquorice
Distinguished Sage
- Mark as New
- Bookmark
- Subscribe
- Subscribe to this message's RSS Feed
- Highlight this Message
- Report Inappropriate Content
Re: BT Homeworker PON flashing after install
Give the FTTP team a call 0800 587 4787
DavidM
Moderator-Retired
- Mark as New
- Bookmark
- Subscribe
- Subscribe to this message's RSS Feed
- Highlight this Message
- Report Inappropriate Content
Re: BT Homeworker PON flashing after install
Hi @CliffordM and thanks for posting.
Did you get this sorted? have you contacted the FTTP team as per @licquorice advice?
Cheers
David
0
Ratings
CliffordM
Aspiring Contributor
- Mark as New
- Bookmark
- Subscribe
- Subscribe to this message's RSS Feed
- Highlight this Message
- Report Inappropriate Content
Hi David,
Yes all sorted, Was sorted within the hour 🙂
Regards
Mike
DavidM
Moderator-Retired
- Mark as New
- Bookmark
- Subscribe
- Subscribe to this message's RSS Feed
- Highlight this Message
- Report Inappropriate Content
Re: BT Homeworker PON flashing after install
0
Ratings