Hello
I have a BT Smart Hub 2.
I was supposed to have Full Fibre 100 connected last week but the Openreach engineer said that because the hub didn't have a red WAN port on it he couldn't connect to it (mine has 4 yellow Ethernet ports) and promptly left.
I contacted customer services who said that they would send out a new hub which I received the following day.
The new hub is a BT Smart Hub - Type A (BT Hub6) and only has 4 yellow Ethernet ports.
I've since looked at the hub managers for each one and found that the Smart Hub 2 allows you to change port 4 to a WAN port to connect full fibre but the new Smart Hub doesn't have this option.
So do you need to connect full fibre to a dedicated red WAN port or would the converted port 4 on the Hub 2 suffice.
Can anyone clarify because I now need to book another engineer, having already waited 5 weeks for the original appointment and don't want to get fobbed of again because the port isn't red.
Thanks
Mark
Solved! Go to Solution.
No idea why you’ve been sent a Smart Hub or why the Openreach bod didn’t know what he was doing. Just enable port 4 as WAN on the SH2 & you’re good to go.
you need to phone CS 150 and get them to send SH2 then when arrived go to hub manager/advanced settings/broadband and toggle FTTP switch to 'on' and you are good to connect ethernet cable from ONT to port 4 now WAN
Thanks for the replies and clearing up which to use. I'm going to go have a little chat with BT 🙂
Mark
@Catteniwrote:Thanks for the replies and clearing up which to use. I'm going to go have a little chat with BT 🙂
I'd suggest that chat should include the word compensation...
Fine as long as you don't require BT Digital Voice service.