Digital voice

[rayclay45]

Installed Smart Hub 2 & DV Adapter - all ok but:

Adapter doesn't go to solid green when paired, is this faulty or can only be solid once I'm switched to DV?

Set up refers to base pin default 000. I haven't changed this as I cannot see it on my Hub Manager. The only option seen is to change admin password - where is the option to change this 4 digit base code?

Thanks Ray

[imjolly]

normally the adapter does not pair until DV is active on SH2  you can check by going to hub manager and should see phone number and whether active or not

[rbz5416 · Accepted solution]

DECT base PINs are usually set from a handset paired to that base, in this case the SH2. If you don't have a BT DV handset paired then I'd suspect it can't be changed.

[rayclay45]

thank you, do you have an answer to the 2nd question re DV Adaptor?

[licquorice]

Which second question would that be? Both questions have been answered.

[rbz5416]

Afraid not beyond what @imjolly has already posted. But maybe try it in the same room as the SH2, just to rule out a range issue.

[rayclay45]

Thank you

[rayclay45]

thank You

[rayclay45]

yes, second question also answere